Concrete Consistency (Slump) Test BS EN12350-2

The SLUMP test shows the workability of concrete. Workability measures how easy the concrete is to place, handle and compact.
Or slump test is a measure of the consistency of the concrete. The consistency therefore is a measure of the water content of the concrete. The water content controls and affects the cement content of the concrete. Since the slump test is important, do not substitute a guess for an actual test.

The slump test is done to make sure a concrete mix is workable.
The measured slump must be within a set range, or tolerance, from the target slump.

 The first step is to take a test sample from the large batch of concrete. This
should be done as soon as discharge of the concrete commences. The sample should be
representative of the concrete supplied.              

Equipment for slump Test

·        Buckets or wheelbarrow
·        Damp cloth
·        Mixing tray
·        Sampling and testing certificates
·        Sampling scoop
·        Standard Slump cone and rigid metal plate (100 mm top diameter x 200 mm bottom diameter x 300 mm high)
·        Slump rod
·        Small scoop
·        Square-mouthed shovel
·        Steel rule

 Slump test procedure

Step 1
• Empty the sampling buckets onto the mixing tray
• Scrape each bucket clean

Step 2
• Thoroughly remix the sample,
shovelling into a heap
• Turn the heap over to form
• Do this three times

Step 3
• Flatten the final
heap by repeatedly
digging-in the
shovel vertically
• Lift the shovel
clear each time

Step 4
• Ensure the slump cone and base
plate are clean and damp
• Place the metal plate on solid
level base away from vibration or
other disturbance
• Place the cone on the plate and
stand on the foot-pieces

Step 5
• Fill the cone in three equal depth
• Use the standard
slump rod
• Rod each layer
25 times
• Spread the blows
• Heap the
concrete above the
top of the cone before rodding the
third layer over the area
• Make sure the rod just penetrates
the layer below

Step 6
• Top up if necessary

• Use the rod
with a sawing
and rolling
motion to strike
the concrete
level with the
top of the cone

Step 7
• Carefully clean off spillage
from sides and base plate whilst
maintaining foot pressure

Step 8
• Carefully lift
the cone straight
up and clear, to a
count of between
2 and 5 seconds

Step 9

• Lay the rod
across the
upturned slump
• Measure
the distance
between the
underside of
the rod and the highest point of the
concrete – the true slump
• Record the distance to the
nearest 10mm
• Check and record the kind of
• If the slump isn’t true, take a
new sample and repeat the test
• If the second slump isn’t true,
get advice
• Complete the sampling and
testing certificates

There are three kinds of slump

  • True
  • Shear
  • Collapse


  • what is slump test
  • concrete slump test
  • slump test for concrete
  • slump test procedure
  • slump test equipment
  • en construction,
  • de construction,
  • Concrete Consistency (Slump) Test BS EN12350-2

Sharing Is Caring

You May Also Like

Next Post »